Catwalk Grate
SKU:
$5.00
$5.00
Making a catwalk by hand is a tedious prospect. Fortunately we make them too. Durable plastic, very thin at only 2mm.
These grates make great floor props, even ventilation covers. The spacing between each grate is wide enough to see objects under it, or above. Place a light source on top and make an interesting shadow effect.
These grates make great floor props, even ventilation covers. The spacing between each grate is wide enough to see objects under it, or above. Place a light source on top and make an interesting shadow effect.
Only a few left!
|
What to Expect:
This is a 3D Printed item. It comes unpainted. Some surface preparation may be needed, such as sanding. This specific item is 50mm X 60mm and 2mm thick. It is printed in PLA plastic, which enables very thin prints while still being strong. The object has been cleaned up from the 3D Printing process, but there may be some areas that might need a bit of sanding and other hands on for clean up. |
Scales Available:
Included in This Kit:
|
Catwalk Grate. Figure and pliers not included.
|
|
